Nortel Networks 24T Instrukcja Użytkownika Pobierz pdf (Strona 59)

100

101

Introduction to the BayStack 410-24T Switch

309985-B Rev 00

1-31

Removing a Unit from the Stack

If a unit is removed from the stack (therefore operating in standalone mode), the

following switch configuration settings revert back to the settings configured

before the unit became a member of the stack:

• IP address

• Console password

• TELNET password

• SNMP community strings

Stack Configurations

As shown in Figure 1-12, the cascade connectors and cables on the 400-ST1 front

panel provide the ability to stack up to eight BayStack switches. With 400-4TX

MDAs installed in each switch, the stack can accommodate a maximum of 224

switch ports.

Because stack parameters are associated with the base unit (see “

Initial

Installation” on page 1-29), the physical stack order depends on the base unit’s

position and whether the stack is configured stack up or stack down.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 309 310

Komentarze do niniejszej Instrukcji

Brak uwag

Nortel Networks 24T Instrukcja Użytkownika Strona 59

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Nortel Networks 24T