Nortel Networks 10BASE-T Instrukcja Użytkownika Pobierz pdf (Strona 138)

Using the BayStack 410-24T 10BASE-T Switch

2-20

309985-C Rev 00

Stack Setup

For the initial setup of a stack configuration, you need to enter the stack IP

address, the subnet mask, and the gateway address (refer to Chapter 3, “

Using the

Console Interface,” for more information about configuring your BayStack

410-24T switch).

To set the stack IP address, subnet mask, and gateway address for the switch:

Connect a console/terminal to one of the switches in the stack.

You can connect a console/terminal to any unit in the stack or to more than

one stack unit (see “

Console/Comm Port” on page 2-10).

Power up the stack configuration.

Observe the console display screen.

After the Nortel Networks logo screen appears, press [Ctrl]-Y:

The console screen temporarily displays the (standalone) Main Menu

screen (see Figure 2-15

This is the same Main Menu screen that is displayed for a standalone

switch, without stacking features.

Within 20 seconds after displaying the standalone Main Menu screen,

the console screen refreshes to show the Main Menu screen for the

stack configuration (Figure 2-16

Although the Main Menu screen for the stack configuration looks similar

to the standalone Main Menu screen, closer observation reveals that the

stack features are included (see bolded text in Figure 2-16

on page 2-21).

Note:

Unless otherwise specified, the terms “switch” and “unit” are used

interchangeably in this guide.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 329 330

Brak uwag

Nortel Networks 10BASE-T Instrukcja Użytkownika Strona 138