Nortel Networks CALLPILOT 555-7101-226 Instrukcja Użytkownika Pobierz pdf (Strona 64)

Installing the server and connecting the peripheral devices Standard 1.01

64 CallPilot

To connect the server to power

1 Plug the server’s AC power cord into the server’s rear panel.

2 Plug the other end into a wall receptacle or power bar.

To start the server

1 Press the server’s power switch to start the server.

2 Observe the Power-On Self-Test (POST) and initialization messages on

the monitor.

3 When the following menu appears on the monitor, choose the first option

to start Windows NT:

OS Loader V4.00

Please select the operating system to start:

Windows NT Server Version 4.00

Windows NT Server Version 4.00 [VGA mode]

WARNING

Risk of personal injury and risk of hardware failure

You must connect the power outlets that are used by the

CallPilot server and its peripheral devices to the same

single-point ground reference as the one used by the

Meridian 1 switch or Succession 1000 system with MGate

cards connected to the CallPilot server.

If this requirement is not met, power transients can cause

personal injury, hardware failure, or both. For more

information on single-point grounding requirements, refer to

the discussion of safety guidelines in CallPilot Installation and

Configuration Part 1: Installation and Maintenance Overview

(NTP 555-7101-210).

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 70 71 72

Brak uwag

Nortel Networks CALLPILOT 555-7101-226 Instrukcja Użytkownika Strona 64