Nortel-networks Nortel Secure Router 4134 Instrukcja Użytkownika Pobierz pdf (Strona 17)

Powering up the Secure Router 4134 17

ATTENTION

When powering up for the ﬁrst time, Nortel recommends that you use a direct

console connection to the Secure Router 4134. After you have completed the

initial conﬁguration, you can use a remote connection for router management.

Procedure steps (AC power)

Step Action

Turn on one power switch at a time (if you installed two AC power

supplies). Power switches are on the rear panel of the Secure

Router 4134.

The fans start immediately, and the LEDs cycle.

Verify that diagnostic testing is underway by observing the startup

messages on your local terminal.

Once the router completes the self-diagnostics tests, verify that the

System LED and the power LEDs that correspond to the power

supplies installed on your router (PS0 and PS1) are green.

Verify that the fan LED on the rear panel of the Secure Router 4134

is green, and air is ﬂowing through the unit.

—End—

Procedure steps (DC power)

Step Action

Turn on the DC power source.

The fans start immediately, and the LEDs cycle.

Nortel Secure Router 4134

Commissioning

NN47263-302 01.02 Standard

10.0 2 August 2007

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

Brak uwag

Nortel-networks Nortel Secure Router 4134 Instrukcja Użytkownika Strona 17