Nortel Networks NTNM13XKAB Instrukcja Użytkownika Pobierz pdf (Strona 33)

Network Wide Backup & Restore Planning Guide Rel 1.0 Standard July 1999

4-1

Network Wide Backup & Restore

Requirements 4-

This section references the various requirements, both hardware and software,

necessary to support the Network Wide Backup & Restore Release 1.0

software.

Hardware Requirements

Since Network Wide Backup & Restore software has to be coresident with

INM Release 5.0, the recommneded hardware platforms of choice are

described in INM Release 5.0 Planning Guide under the section “INM Release

5.0 Requirements”.

Operating System Requirements

HP workstations must run HP-UX Release 10.20 ACE, and HP-VUE 3.0 to

support Network Wide Backup & Restore.

Again since Network Wide Backup & Restore software is coresident with INM

Release 5.0, refer to INM 5.0 Planning Guide for detailed information on

operating system requirements and HP-UX 10.20 software patches.

First Time Installation

If the workstation is purchased from Northern Telecom (Nortel), the HP-UX

operating system is installed and configured.

However, the following tasks must be performed before installing the

software:

• Connect the workstation to the local area network (LAN).

• Configure HP-UX 10.20 ACE according to the requirements for INM

Release 5.0 (refer to HP-UX System Administration Tasks manual for this

procedure).

• Modify the HP-UX kernel parameters as required (refer to HP-UX System

Administration Tasks manual for this procedure). This procedure verifies

the setup of the HP-UX kernel parameters described in INM 5.0 Planning

Guide.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 44 45

Brak uwag

Nortel Networks NTNM13XKAB Instrukcja Użytkownika Strona 33